SMD REMOVAL ALLOY CHIP QUIK SMD16

$98.00

Easily remove SMD parts with Chip Quik® removal alloy.
• Reduce heat and reduce damage to circuit boards
• Melting Point: 58°C (136°F)
• 16ft. In 30-6.5 in. length
• Use with SMD291 flux

TOTAL BULK PRICE

x
SKU: SMD16 Category:

Description

SMD Removal
(With solder iron or hot air)
· Apply flux to all leads.
· Melt CHIP QUIK® uniformly on all pins.
· Maintain alloy in a molten state long enough to release the chip.
· Lift chip from the board with a dental pick or vacuum pen.

CLEAN UP
· While molten, use cotton swab and flux to move the excess to an unused section of the board.
· While applying heat, polish each pad with a swab and flux until thoroughly clean.
· At room temperature, clean residue with an alcohol pad.
· You are now ready to install the new chip.
2.5 ft of Chip Quik® material, remove 1250 to 1500 SMD pins.

Conforms to the following Industry Standards:
J-STD-006C, Amendments 1 & 2 (Solder Alloys and Fluxed/Non-Fluxed Solders): Yes
RoHS 2 Directive 2011/65/EU: No

You may also like…

Title

Go to Top